Bitsum Community Forum

General Category => Process Lasso => Topic started by: tsorzano on June 28, 2012, 09:26:52 AM

Title: Watchdog not terminating processes
Post by: tsorzano on June 28, 2012, 09:26:52 AM
I downloaded the demo process lasso server v5.1.0.98.  Running on windows 2003 terminal server.  I installed to see all user processess but only run manager and agent in my admin account.   I disabled probalance features.

I want a watchdog to terminate any processes that takes 95% of cpu for more then 15 seconds.

I used * for the process name.  Is that a valid entry to specify any process?

To test I browsed to hxxp://www.fossiltoys.com/cpuload.html  and selected 100%.

Watching the lasso manager I can see iexplore.exe taking 100% of the cpu.  However the watchdog never terminates the process.

Any suggestions

Thanks,

Troy
Title: Re: Watchdog not terminating processes
Post by: Jeremy Collake on June 28, 2012, 06:30:38 PM
I am not sure what the malfunction may be, but you may want to try a Restart instead of Terminate, see if it changes the behavior. You may have stepped into a safety catch...

I STRONGLY RECOMMEND you not use '*' though and instead target specific process(es). You can use wildcards, just not one that includes all processes on a 'Terminate' rule.. For your own safety. Also note this operation is very unsafe. The entire rule is unsafe, but the termination itself is also quite unsafe (inherently as a forced termination).

You might have better luck with ProBalance, if your intent is what I believe it to be. Check the extended options in the ProBalance configuration dialog.

Version 6 further expands the watchdog rules a lot, BUT it is still in early alpha so would need to be used with great care.