PL - Creating Narrow Main Window Display

Started by MMcVeigh, April 25, 2015, 02:06:21 PM

Previous topic - Next topic

MMcVeigh

Some versions back, the main PL window could be manually sized to show as few as two columns.  I like to have PL running showing just a narrow display on the side of the screen with narrow performance graph and CPU utilization.  Newer versions cannot be squeezed very far.  I wrote about this previously and the response was the change was due to attempts to fix overlapping tab areas.  At that time you said to mention my request again later. 

Please see if you can edit the GUI layout so that I can squeeze the window to a narrow display.  I have attached an example.

Jeremy Collake

Software Engineer. Bitsum LLC.

MMcVeigh

#2
Jeremy, It has been several months with no word on this request. 

What is the status please?

Thanks,
Mark

Jeremy Collake

I did work on this, by resolving the display problem through limiting the minimum window width. You can no longer squeeze it to such a small width.

Whether I allow it to be minimized to a thin X pixels wide, I don't know. It complicates things, but I'll give it some thought.
Software Engineer. Bitsum LLC.

John Safford

Have teh same need as MMcVeigh
Good product have bought many to keep old laptop installs going.
1280X1024 screens this window is way too big.
Any kind of hack to narrow the window - Even temporarily?   
The "dirty hack" for XP worked just fine but reset when you opened the window.