NOTICE: This forum is mostly an archive, though new posts are allowed. Registration may require manual admin activation. After registering visit https://bitsum.com/contact/ to request account activation.
Started by SquidNinja, August 02, 2014, 03:32:44 AM
QuoteI made sure the program was run as admin each time, and even tried without admin rights, but the problem remained. I opened the power options to test the reg tweak I downloaded, and noticed a similar issue. I could not change either value without it resetting to zero every time I left the field. I should note that these are not the same values as the ones I reg-edited; the power options are at 0% - referring to the amount of cores to be unparked at all times- and the registry values I changed myself were something else (I actually don't remember at the time of writing).